In-Line 6, Vee 8, Vee 12, Vee 16, 4-Stroke-Cycle Diesel
Bore
11in
Stroke
11.8in
Maximum Width
69in
Minimum Height
108in
Minimum Dry Weight
34496lb
Maximum Height
140in
Minimum Width
67in
Minimum Length
145in
Maximum Length
197in
Maximum Dry Weight
62832lb
Air Inlet System
R INLET SYSTEM Aftercooler, fresh water, corrosion resistant coated (air side) Air inlet shutoff Breather, crankcase, top-mounted Turbocharger, rear-mounted, engine oil lubricated
Control System
Single Caterpillar A-III Electronic Engine Control Modules with Electronic Unit Injector Fuel System Rigid Wiring Harness (10 amp 24volt power required to drive Electronic Engine Control Modules)
Cooling System
Engine coolant water drains
Exhaust System
Dry, gas tight, exhaust manifold
Fuel System
Distillate fuel (requires viscosity ranging from 1.4 cSt to 20 cSt at 38 degrees C) Fuel transfer pump (mounted on left hand side) Duplex fuel filters Electronically Controlled Unit Injectors
Lube System
Centrifugal oil filters with single shutoff. Service side engine mounted on cylinder block inspection covers. Includes installed oil lines and single shutoff valve. Filters centrifuge bypass oil from the main lubricating oil pump. Can be serviced with the engine running. Oil filler and dipstick Valve, oil pressure regulating Valves, crankcase explosion relief
Service literature. Included standard with each engine are two (2) complete sets of service literature listed below: 1. Custom parts book CD (serial number specific) 2. Service manual, which includes: Operation & Maintenance, Specifications, Systems Operation, Testing and Adjusting, Disassembly and Assembly manual. Available in paper media and English language only. 3. Technical manual (parts/service information for special equipment). Available in paper media in English language only. NOTE: Custom parts book CD and service manual can be re-ordered through the normal Caterpillar literature ordering system. The technical manual can only be re-ordered through the Project Services at the Caterpillar Lafayette Engine Center facility.
Air Inlet System
Air Cleaners
Cooling System
Jacket Water Heaters
Heat Recovery System
Heat Recovery Thermostats
Cooling System Connection Groups
De-Aerator
Control System
Load Sharing module
Direct Rack Module
Exhaust System
Outlet Expander
Flexible Exhaust Fittings
Weld Flange – Optional
Fuel System
Fuel Priming Pump
Duplex Primary Fuel Strainer
Fuel System Connections
Lube System
Oil Pan Drain Valve
Prelubrication Connections
Lube Oil Heater
Mounting System
Vibration Isolators
Marine Society Requirements
Spray shielding
Protection System
PLC Monitoring System Options
ECP Relay System Options
ECP Mechanical Gauge Instrument Panel
Turbocharger Speed Sensor
Cylinder Pressure Relief Valve
Oil Mist Detector
Protection System Components
Magnetic Pickup
Spare Part Kits
Intake and Air System
Basic Engine
Cylinder Head
Fuel System
Cooling System
Instrumentation
Cylinder Valve Kits
Engine Testing
Basic System Testing
Special Witness Test
Torsional Vibration Analysis
Service Tools / Shipping Protection / Factory Support
