Engine
- Net Power - SAE J1349
-
538HP
- Engine Power - ISO 14396
-
580HP
- Engine Model
-
Cat® C18 ™
- Gross Power - SAE J1995
-
588HP
- Rated Speed
-
1,700 rpm
- Peak Power Speed
-
1,500 rpm
- Emissions
-
U.S. EPA Tier 4 Final, EU Stage V, and Japan 2014
- Bore
-
5.7in
- Stroke
-
7.2in
- Displacement
-
1105in³
- Peak Torque - 1,200 rpm - SAE J1995
-
2230ft·lbf
- Torque Rise
-
58%
Operating Specifications
- Operating Weight
-
116362lb
- Operating Weight - Standard
-
116362lb
- Operating Weight - High Lift
-
119618lb
- Rated Payload - Standard (Quarry Face)
-
12.5ton (US)
- Rated Payload - Loose Material (Standard)
-
16ton (US)
- Bucket Capacity Range
-
4.7-13 m3 (6.2-17 yd3)
Transmission
- Transmission Type
-
Cat switched reluctance electric drive
- Forward 1 (virtual)
-
4.3mile/h
- Forward 2 (virtual)
-
7mile/h
- Forward 3 (virtual)
-
13.8mile/h
- Forward 4 (virtual)
-
20mile/h
- Reverse 1 (virtual)
-
4.3mile/h
- Reverse 2 (virtual)
-
7mile/h
- Reverse 3 (virtual)
-
17.5mile/h
Hydraulic System - Lift/Tilt
- Lift/Tilt System - Circuit
-
EH-Positive Flow Control, Flow Sharing
- Lift/Tilt System - Pump
-
Variable displacement piston
- Maximum Flow at 1,400-1,600 rpm
-
153gal/min
- Relief Valve Setting - Lift/Tilt
-
4757psi
- Lift Cylinder - Bore
-
8.7in
- Lift Cylinder - Stroke
-
41.3in
- Tilt Cylinder - Bore
-
8.7in
- Tilt Cylinder - Stroke
-
27in
Hydraulic Cycle Times
- Rack Back
-
4.5s
- Raise
-
8s
- Dump
-
2.2s
- Lower Float Down
-
3.5s
- Total Hydraulic Cycle Time
-
18.2s
Hydraulic System - Steering
- Steering System - Circuit
-
Pilot, load sensing
- Steering System - Pump
-
Piston, variable displacement
- Maximum Flow at 1,400-1,600 rpm
-
71.3gal/min
- Steering Cut Off Pressure
-
4351psi
- Total Steering Angle
-
86°
- Steering Cycle Times - High Idle
-
3.4s
- Steering Cycle Times - Low Idle
-
5.6s
Air Conditioning System
- Air Conditioning
-
The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes.
Axles
- Front
-
Fixed
- Rear
-
Trunnion
- Oscillation Angle
-
13°
Brakes
- Brakes
-
ISO 3450:2011
Operator's Cab
- ROPS/FOPS
-
ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards
Service Refill Capacities
- Fuel Tank
-
147gal (US)
- Cooling System - Jacket Water
-
30gal (US)
- Cooling Systems - Power Train
-
8gal (US)
- Engine Crankcase
-
16gal (US)
- Diesel Exhaust Fluid Tank
-
8.7gal (US)
- Transmission
-
16gal (US)
- Differential - Final Drives - Front
-
49gal (US)
- Differential - Final Drives - Rear
-
49gal (US)
- Hydraulic System - Implement/Steering
-
126gal (US)
- Note
-
All nonroad Tier 4 Final/Stage V diesel engines are required to use: – The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less). – Cat engines are compatible with the following renewable, alternati
Sound Performance - Tier 4 Final/EU Stage V - Standard
- Operator Sound Level (ISO 6396)
-
72dB(A)
- Machine Sound Level (ISO 6395)
-
109dB(A)
- Note (1)
-
The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
- Note (2)
-
Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
- Note (3)
-
The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Dimensions (Approximate) - Standard Lift
- Ground to Top of ROPS
-
13.8ft
- Ground to Top of Exhaust Stacks
-
14.8ft
- Ground to Top of Hood
-
10.9ft
- Ground to Bumper Clearance
-
3.1ft
- Rear Axle - Centerline to Bumper
-
10.5ft
- Front Axle Centerline to Bucket Tip
-
14ft
- Wheel Base
-
14.9ft
- Maximum Overall Length
-
39.3ft
- Ground to Lower Hitch Clearance
-
1.9ft
- Ground to Center of Axles
-
3.2ft
- Clearance at Maximum Lift
-
11.9ft
- B-Pin Height - Maximum Lift
-
18ft
- Maximum Overall Height - Bucket Raised
-
24.5ft
- Reach - Maximum Lift
-
6.5ft
- Note
-
Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Dimensions (Approximate) - High Lift
- Ground to Top of ROPS
-
13.8ft
- Ground to Top of Exhaust Stacks
-
14.8ft
- Ground to Top of Hood
-
10.9ft
- Ground to Bumper Clearance
-
3.1ft
- Rear Axle - Centerline to Bumper
-
10.5ft
- Front Axle Centerline to Bucket Tip
-
15.3ft
- Wheel Base
-
14.9ft
- Maximum Overall Length
-
40.7ft
- Ground to Lower Hitch Clearance
-
1.9ft
- Ground to Center of Axles
-
3.2ft
- Clearance at Maximum Lift
-
13.3ft
- B-Pin Height - Maximum Lift
-
19.3ft
- Maximum Overall Height - Bucket Raised
-
25.8ft
- Reach - Maximum Lift
-
6.8ft
- Note
-
Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Dimensions - Millyard Linkage
- Ground to Top of ROPS
-
13.8ft
- Ground to Top of Exhaust Stacks
-
13.8ft
- Ground to Top of Hood
-
10.9ft
- Ground to Bumper Clearance
-
3.1ft
- Rear Axle - Centerline to Bumper
-
10.5ft
- Front Axle Centerline to Fork Tip
-
16.5ft
- Wheel Base
-
14.9ft
- Maximum Overall Length
-
41.9ft
- Ground to Lower Hitch Clearance
-
1.9ft
- Ground to Center of Front Axle
-
3.2ft
- Fork Height with Level Arms
-
8.1ft
- Fork Top Clamp Opening
-
13.1ft
- Fork Height at Maximum Lift
-
17.2ft
- Hinge Pin Height at Maximum Lift
-
16.1ft
- Dump Angle at Maximum Lift
-
-39.4°
Buckets
- Bucket Capacities
-
4.7-13 m3 (6.2-17 yd3)
Sustainability
- Recyclability
-
96%
Exterior View